How do we fit the Set Screw Rotor with a Servo Clamp Stator?

  1. Fit IncOder Stator & Rotor around the shaft
  2. Fit IncOder Stator using servo clamp screws – gradually tightening opposite screws
  3. Place plastic setting pieces between faces of Stator and Rotor/Collar
  4. Abut the Rotor to the setting pieces
  5. Secure Collar using grub screws – gradually tightening opposite screws
  6. Remove the setting pieces
  7. Check that gap is within the range 1.45mm to 0.75mm.

When fitting a Mini or Ultra series IncOder, please refer to the installation tolerances specified in the IncOder product guides.

< Back to FAQs

Further information on Zettlex Products